Micro Cooling Fan production process

First "Micro Cooling Fan" on the wire material, a small motor (on the car demolished), water pipes (not soft to hard point), universal table, a small fan, six foot switch, as well as soldering pen. First, measuring six foot table with a universal connector switch, switch press down resistance is 0, not by Resistance lot on the line. The pipe cut, try size. The motor and "dota2雷竞技预测 " even from the solder two wires on the motor, and then welded to one end of the switch, the other end of the iron plates, drilled a hole in the pipe opposite to iron insert. Cutting a big hole in the top, squeeze the switch (you can use hot solder pen), the "dota2雷竞技预测 " small motor fixed, (note the connection end toward the inside), wrapped with tape. Switch the other end of the wire, the wire connected to the iron, solder weld.